Safety Instructions; Installation Instructions - GRE CFAQ35 Manuel D'instructions

READ CAREFULLY AND SAVE FOLLOWING INSTRUCTIONS BEFORE OPERATION
EN

SAFETY INSTRUCTIONS

The following important points should be read and under stood prior to use:
1 . The maximum head of the pump is 3.7m (for pumps having rated power input exceeding 100W).
Maximum liquid temperature: 35°C
2. Make sure the pump be fixed before using each time with the screws.
3.This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been given
supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved.
4. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision. The supply cord cannot be replaced. If the cord is damaged the
appliance should be Scrapped.
5. The pump must not be used when people are in the water. The supply cord cannot be replaced. If the
cord is damaged the appliance should be scrapped.
6. WARNING The pump is to be supplied by an isolating transformer of supplied through a residual
current device(RCD) with a rated residual operating current not exceeding 30mA
7. WARNING To prevent possible electric shock, do not attempt to plug in power cord with wet hands
of while standing in water.
8. WARNING Make certain before each use of pump that all clamps are tightened and that all hoses
are connected properly.
9. WARNING Do not use this filter pump to vacuum pool.
10.WARNING Never 230 V power adapter near a swimming pool. Transformers and power outlet should
be 3.5 meters or more away from the pool. Filter pump and power adapter may not be installed in
flooded areas (where no suitable power outlet).

INSTALLATION INSTRUCTIONS

1. Set up your Pool exactly. Fill it completely with water.
2. Position the filter pump unit at least 20 cm below the highest water level in the pool.
3. And keep the filter pump at least 60 cm away from the sidewall of the pool.
4. Place Aqualoon and bottom sponge into the body of the filter pump.
5. Make certain that the filter chamber rubber gasket is placed in the seal groove on the top of the filter
pump.
6. Screw on filter chamber cover onto top of the body of filter pump by hand.
7. Connect the hoses same as the Installation iIIustration, fixture the pump to the wall of pool. Remember
to use hoseclamp, tighten it secondly with screwdriver.
8. Allow time for filter pump chamber to full with water. Never operate the filter pump dry.
9. Check the location authorities to determine the appropriate standard and requirements for electronic
installation. Connect electrical power cord into a grounded receptacle protected by a ground-fault
circuit interrupter(GFCI). Please contact a qualified electrician for verification purposes and/or
installation of a GFCI receptacle if necessary.