Pipe Connections; Cell Power Connection - Davey EcoMatic COMM500 Instructions D'installation Et D'utilisation

Pipe connections

NOTE: If a heater is installed, Davey recommends installing it on a bypass such that water above 30°C
(86°F) does not pass through the cell.

Cell power connection

Push cell sockets (female) from the end of cell lead onto the plugs (male) on the cell as illustrated below
ensuring correct colour configuration. Once attached, tighten nut on cell socket to ensure a tight fit.
Overheating of connection may occur otherwise.
Cell lead from
power supply
Cell power terminal connectors
(2 black, 1 red/white)
Flow switch circuit
(female & male)
9
Cell gas
sensor socket
Flow switch