EGO EA0800 Guide D'utilisation page 7

◾
Store Idle Appliances Indoors - When not in use, appliances should be stored
indoors in a dry and high or locked-up place with the battery pack removed- out
of reach of children.
◾
Maintain Appliance with Care - Keep cutting edge sharp and clean for best
performance and to reduce the risk of injury. Follow instructions for lubricating
and changing accessories. Keep handles dry, clean, and free from oil and grease.
◾
Check Damaged Parts - Before further use of the product, a guard or other part
that is damaged should be carefully checked to determine that it will operate
properly and perform its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting, and any other condition
that may affect its operation. A guard or other part that is damaged should be
properly repaired or replaced by an authorized service center unless indicated
elsewhere in this manual.
◾
Clear the area to be cut before each use. Remove all objects such as rocks,
broken glass, nails, wire, or string that can be thrown or become entangled in the
cutting attachment.
◾
Always hold the edger firmly, with both hands on the handles, while
operating. Wrap your fingers and thumbs around the handles.
◾
Avoid Accidentally Starting - Don't carry the edger with your finger on the
trigger.
◾
Do not operate the edger in gaseous or explosive atmospheres. Motors in
these appliances normally spark, and the sparks might ignite fumes.
◾
Do not use the edger on or near graveled surfaces.
◾
Damage to Edger - If you strike a foreign object with the edger, stop the tool
immediately, check for damage and have any damage repaired before further
operation is attempted. Do not operate with a broken guard or blade.
◾
Replace a cracked, damaged or worn-out blade immediately, even if
damage is limited to superficial cracks. Such attachments may shatter at
high speed and cause serious or fatal injury.
◾
Do not charge the battery pack in rain, or in wet locations.
◾
Use only with the battery packs and chargers listed below:
BATTERY PACK
BA1120, BA1120-FC, BA1400, BA1400-FC,
BA2240, BA2240-FC, BA2800, BA2800-FC,
BA4200, BA4200-FC
◾
Use Only With The 56V Lithium-Ion Power Head PH1400/PH1400-FC.
EDGER ATTACHMENT — EA0800/EA0800-FC
CHARGER
CH2100, CH2100-FC,
CH5500, CH5500-FC
7