MRA KAWASAKI KLZ Versys 1000/SE 2019 Instructions De Montage page 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
2 24 X 8 X 5 MM NEOPRENE WASHER
2 30 X 8 X 10 MM NEOPRENE WASHER
1. Place the motorcycle on a flat surface.
2. Disassemble the original windscreen.
3. Remove the fastening panels, the metal sleeves and the fastening screws from the
original windscreen (P1).
4. Insert the metal sleeves through the lower drill holes of the covering panels from above
(P2).
5. Guide the metal sleeves though the lower drill holes of the MRA windscreen and attach
the thicker spacers supplied from the back (P3).
6. Mount the MRA windscreen to the motorcycle using the lower fastening screws and
tighten these only slightly (P4).
7. Now, attach the other metal sleeves through the upper drill holes of the fastening panels
and attach the thinner spacers supplied into position in such a way that these align with
the drill holes. Guide the fastening screws through the sleeves and the spacers and
tighten the screws slightly (P5).
8. Check the correct position of all rubber parts and then tighten the screws.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
Kawasaki Versys 650/1000 17-
Article No..
--- Allen key 4mm
11406
11407
3
Required tools