ARENDO SOLID Mode D'emploi page 52

4. Initial start-up
When the device is put into operation for the first time, check the intactness of
the product or components and their function again. Please remove the kettle and
the heating element from the packing and clean the unit with a damp cloth. Af­
terwards connect the kettle only to a properly installed grounded socket. Before
regular use, fill the water reservoir with cold water to its maximum level and boil
according the following instructions. Thereafter discard the water in order to re­
move any residues of the production process.
5. Handling
Press the opening button to open the cover. Then fill the Arendo kettle with cold
water and close the cover by pressing down the cover until it locks.
Important note: Please make sure not to fill in more than the maximum level of 1,7
l as marked on the scale, which is located on the right inner side.Place the kettle
on to the bottom heating and set the On/Off button downwards to heat the water.
As soon as the target temperature has been reached, the kettle will automatically
turn off.
6. Decaling and cleaning
We recommend decalcifying the kettle in regular intervals, depending on the
intensity of use. Before cleaning, it is essential to remove the power plug from the
socket and wait until the device is completely cooled down. Only use convention­
al decaling agents based on citric acid. Please follow the manufacturer´s instruc­
tions for dosing the respective product you have chosen. The heating element
must not be cleaned and never be processed with sharp or hard objects. For
cleaning the outer surface of the kettle, only use a damp cloth. Never use hard or
abrasive objects like a wire brush or a steel-sponge for cleaning. Please do not use
any aggressive cleaning agents which could be harmful for human consumption
or damage the surface. To avoid the risk of electric shock, never immerse the
device, the power cord or the plug in water or other liquids.
52
English