eQ-3 WFC 310 Manuel D'utilisation page 20

6. Operations
Alarm function
• Press the <ALARM> button for at least three seconds to
set the alarm time. The text "ALM" and the hours display
flash. Use the <+> button for the hour setting. By pressing
the <ALARM> button again, the minute setting is activated.
The minute display flashes. Use the <+> button for the
minutes setting. Press the <ALARM> button again to end
the setting mode for the alarm time.
• Use the <ALARM> button to activate or deactivate the
alarm. When the alarm is active, the alarm symbol "((( • ))"is
shown on the display.
• The alarm signal can be interrupted with the <ALARM>
button. Use the <SNOOZE> button to stop the alarm signal
for five minutes. During this time, the alarm signal "((( • ))) "
flashes.
Outdoor temperatur
• MIN/MAX can be resetted by pressing the SNOOZE key
during 3 seconds.
positioning the temperature transmitter:
The transmitter is supplied with a holder that may
be attached to a wall with the two screws supplied.
The transmitter can also be position on a flat sur-
face by securing the stand to the bottom to the
transmitter.
To wall mount: Mount at a sheltered place. Avoid
direct rain and sunshine.
1. Secure the bracket onto a desired wall using the
2. Clip the remote temperature sensor onto the
note!
Before permanently fixing the transmitter wall base,
place all units in the desired locations to check that
the outdoor temperature reading is receivable. In
event that the signal is not received, relocate the
transmitter or move it slightly as this may help the
signal reception.
0
screws and plastic anchors.
bracket.