Operating The Mpc01 - Dometic GROUP Waeco PerfectControl MPC 01 Instructions De Montage Et De Service

PerfectControl MPC01
Connecting the battery sensor
I
NOTE
The battery sensor requires a rest period of approximately 8 hours for calibra-
tion.
In "boat" and "caravan" operating modes, the consumer batteries A, B and C can be con-
nected in addition to the motor battery.
In "boat" operating mode, the battery connection IBS_B2C is not factored into the calcu-
lation of the total current and voltage shown in "Supply batteries overview". As a rule, the
battery sensor for the sideshift bow thruster should be plugged into battery
connection IBS_B2C.
➤ Connect the battery sensor connection cable (fig. 1 6, page 3) to the battery sensor
(fig. 1 5, page 3).
➤ Connect the battery sensor to the negative pole of the battery.
➤ Clamp the blue cable of the connection cable of the battery sensor (fig. 1 6, page 3)
onto the positive pole of the battery (voltage supply).
➤ Plug the red cable with the white plug connection onto the corresponding CI bus con-
nection on the adapter board (fig. 5 6–10, page 3).
Connecting the MPC01 to the voltage supply
➤ Plug the cable lug end of the red cable (fig. 1 10, page 3) onto the left contact of the
voltage supply connection of the adapter board (fig. 5 3a, page 5).
➤ Connect the end of the red cable with the round cable lug to the positive battery pole.
➤ Plug the cable lug end of the black cable (fig. 1 9, page 3) onto the right contact of
the voltage supply connection of the adapter board (fig. 5 3b, page 5).
➤ Connect the cable lug eye of the black cable to the consumer unit connection contact
of the battery sensor on a negative battery pole (fig. 6 1, page 5).
Connecting power consuming devices to the battery sensor
➤ Always connect the negative pole of the power consuming devices to the correct con-
nection on the battery sensor (fig. 6 1, page 5).
8

Operating the MPC01

Navigating within the menu
Navigate through the menus as follows:
➤ Turn the selector button (fig. 2 2, page 3) to scroll through the individual pages in the
menu or through the items appearing on one page of the menu.
➤ Press the selector button to access the sub-menus or change mode.
➤ Turn the selector button until the message "Press to return" appears and then press
the selector button.
✓ This will return you to the "Main menu".
The following four figures show how you can navigate within the menu:
EN
Operating the MPC01
29