Safety Instructions - Dometic GROUP Waeco PerfectControl MPC 01 Instructions De Montage Et De Service

Safety instructions

Fig. 1 5, page 3: This refers to an element in an illustration. In this case, item 5 in
figure 1 on page 3.
2 Safety instructions
The manufacturer accepts no liability for damage in the following cases:
 Damage to the product resulting from mechanical influences and excess voltage
 Alterations to the product without express permission from the manufacturer
 Use for purposes other than those described in the operating manual
Please observe the following basic safety information when using electrical devices to
prevent:
 Electric shock
 Fire hazards
 Injury
WARNING!
!
 Electrical devices are not toys!
Always keep and use the device out of the reach of children.
 People (including children) whose physical, sensory or mental capacities or
whose lack of experience or knowledge prevent them from using this product
safely should not use it without the supervision or instruction of a responsible
person.
 Only use the device as intended.
 Make sure that the lead has a sufficient cross-section.
 Lay the cables so that they cannot be damaged by the doors or the bonnet.
Crushed cables can lead to serious injury.
CAUTION!
!
 Lay the cables so that they cannot be tripped over or damaged.
 Do not operate the device
– In salty, wet or damp environments
– In the vicinity of corrosive fumes
– In areas where there is a danger of explosions.
 Always disconnect the power supply when working on the device.
 Please observe that parts of the device may still conduct voltage even if the
fuse has blown.
 Do not disconnect any cables when the device is still in use.
NOTICE!
A
 Use ductwork or cable ducts if it is necessary to lay cables through metal pan-
els or other panels with sharp edges.
 Do not lay the cable so that it is loose or heavily kinked.
 Fasten the cables securely.
24
PerfectControl MPC01
EN