Technical Description; Display And Control Elements - Dometic GROUP Waeco PerfectControl MPC 01 Instructions De Montage Et De Service

Technical description

6 Technical description
6.1 Function
The current status information for each battery connected via a battery sensor appears
on the display: current, voltage, temperature, remaining charge time and remaining ca-
pacity (in %) of all consumer batteries connected.
Included with the MPC01 is one battery sensor for connecting one battery. To connect
more batteries you need additional battery sensors (item no. 9102500038) (accessories).
MPC 01 enables the charge status of the starter battery and up to three supply batteries
to be monitored. To do so, the battery sensors are connected to the negative pole of the
batteries. The information read out from them is transmitted to the display via the CI bus
interface. The battery sensors measure the voltage, current and temperature of the con-
nected battery. Along with the battery sensor supplied, up to three more battery sensors
(accessories) can be connected.
MPC01 features three programmable outputs for switching off consumers should the bat-
tery capacity be too low (battery monitor function).
The battery charger is connected to the display via the CI bus interface.
MPC01 features a display mode, and a stand-by mode which is activated after a preset
interval.
A programmable alarm function reminds the user of the preset time.
A jumper allows the operating mode to be changed from "caravan" to "boat".
6.2

Display and control elements

No. in
fig. 2, Designation
page 3
1 Display
2 Selector button
26
Explanation
Shows values
Turn: Navigate through menus or change values
Press: Select menu items or values
PerfectControl MPC01
EN