Using The Chronograph; Chronograph Reset (Incl. After Replacing Battery) - Lotus ILMOS49 Mode D'emploi

USING THE CHRONOGRAPH

This chronograph is able to measure and display time in 1/20(1/1) second united up to
maximum of 60minutes.
The retrograde chronograph 1/20(1/1) second hand keeps continuously for 60 seconds
after starting, and then stops at ZERO position.
[Measuring time with the stopwatch]
1. Press button "B" to change the watch to the chronograph mode. The second hand stops at
the ZERO second position, and changes to the chronograph 1/20(1/1) second hand.
2. The chronograph can be started and stopped each time button "A" is pressed.The
chronograph 1/20(1/1) second hand stops at the ZERO second position 60 seconds
after starting, When button "A" is pressed to stop the chronograph, the chronograph
1/20(1/1) second hand advances rapidly to display the measured time.
3.
Pressing button "B" resets the chronograph and all hands return to their ZERO positions.
Reset Time measurement
ILM0S49
Stop
16
ILM0S49
CHRONOGRAPH RESET
(incl. aftEr rEplacing battEry)
This procedure should be performed when the chronograph second hand and
chronograph 1/20(1/1) second hand do not return to the ZERO second position after
the chronograph has been reset, and including after the battery has been replaced.
1. Pull the crown out to the 2nd position.
2. Press button "A" to set the chronograph second hand to the ZERO position.
3. Press button "B" to set the chronograph 1/20 second hand to ZERO position.
The chronograph hands can be advanced rapidly by continuously pressing button "A"
or "B".
4. Once the hands have been zeroed, reset the time and return the crown to its normal
position.
5. Press button "B" to check that the chronograph hands are reset to the ZERO position.
* Do not return crown to the normal position while chronograph second hand and
1/20 chronograph second hand return to ZERO position.
Each hands stop on the way when crown are returned to normal position and these
positions are recognized as ZERO position.
17