Stopping The Machine; Blade Adjustment; Machine Cleaning - Enerco TIFON 600 Série Mode D'emploi

STOPPING THE MACHINE

Petrol engine:
Never use the choke to stop the engine. Leave the machine run at an idle speed for 2-3 minutes to
cool down
Move the Gas lever to minimum throttle.
Turn the button, which is on the gasoline engine, to the OFF position to stop the machine lastly.

BLADE ADJUSTMENT

The blade pitch control wheel is easy to reach for the operator. To adjust the pitch, just turn the
wheel clockwise or anticlockwise, depending on the desired pitch position. During finishing, setting
up/hardening may vary from area to area across the floor, so the pitch adjustment can be changed
to suit accordingly while the machine is in operation. When transporting the trowel on a truck, always
keep blades fully horizontal/flat on the floating disc.
MAINTENANCE TABLES
Power trowels with petrol engine:
CLEAN THE MACHİNE BYE PRESSURIZED WATER
en
CHECK THE BLADE PITCH ADJUSTMENT
CHECK THE BLADE PITCH BOLTS AND CHECK OTHER BOLTS OF
THE MACHINE, IF NECESSARY TIGHTEN THEM
CHECK ENGINE OIL LEVEL
CLEAN AIR FILTER
CHECK THE V-BELT TIGHTNESS
CHECK THE BLADES
CHANGE ENGINE OIL
PUT OIL TO THE GREASE FITTINGS
GEARBOX
Check the gearbox oil level before every operation; change the gearbox oil every year. On the side
of the gearbox there is a plug. Use "SHELL TİVELA COMPOUNDS A (400gr)" gear oil or equivalent.

MACHINE CLEANING

Clean the machine after it has been used to prevent the collection of hardened cement. Hard
concrete/cement paste is very difficult to remove. To clean it, use an old brush or hand brush.
8
DAILY
X
X
X
X
X
TROWELS TIFON 600/900/1200 WITH PETROL ENGINE
WEEKLY
X
X
X
X
X