Securing The Child In The Seat - kiwy SPF 1 SA-ATS Mode D'emploi

Pull out the car safety seat belt and place it between the
backrest and the seat frame (Fig. 15).
Slot the buckle tongue in the car seat buckle (Fig. 16) until
it clicks in.
Pass the lap section (Fig. 17) in the lower red belt guides
on both sides of the seat frame. Insert the diagonal seat
belt section through the red belt clamp (Fig. 18).
Warning! Ensure that the belt has not been twisted
!
(Fig. 19).
Press the child seat firmly against the vehicle seat and
back of the vehicle seat and at the same time, pull tightly
upwards the diagonal section of the seat belt through the
belt clamp (Fig. 20) until there is no slack; then close the
belt clamp (Fig. 21).
caution! The diagonal seat belt section must be clamped
using only the belt clamp on the opposite side of the ve-
hicle seat buckle;
Adjust the height of the support leg by pressing the pu-
shbutton located at its back (Fig. 22) and slide down the
lower section until it reaches the floor of the vehicle.
Release the button and check that the support leg is lo-
cked in position and its bottom well in contact with the
vehicle's floor.
Important: When adjusting the support leg, make sure
that the base of the seat always remains in contact with
the seat (Fig. 23) and not elevated.
You may now use the child seat at your chosen position,
by using the reclining lever (Fig. 24).
Removing the child seat from the vehicle
Grip the reclining lever (Fig. 13) and pull the seat forward
to the reclined position.
Open the clamp in which the seat belt is engaged.
Release the vehicle seat belt from its buckle.
Take the lap seat belt section off the red belt guides and
withdraw the vehicle seat belt to remove the child seat
from your vehicle.
III. sEcurInG thE chIld In thE sEat:
Press the red button on the buckle to unlock it (Fig. 25).
Loosen the shoulders' straps by pulling both simultaneously,
while holding the harness release button down (Fig. 26).
Place your child in the child seat and fit the left and right
5