Epson OT-SC20 Manuel D'utilisation page 8

Cleaning the Charge Terminals
Charges may not be performed properly if there is dirt or foreign material on the charge
terminals. Be sure to pull the AC cable from the outlet. Then, wipe off dirt with a dry cloth
or cotton swab. Epson recommends cleaning the parts periodically (generally every 3
months).
!K
CAUTION:
❏
After charging, the charge terminals can be very hot. Be careful not to touch them and
to let them cool before you clean them.
❏
Do not damage the charge terminals by touching them with your fingers or any hard
object.
❏
Do not expose the charge terminals to water. Perform the cleaning using a dry cloth or
cotton swab.
Troubleshooting
Charge LED does not turn on
❏
Check that the AC adapter is properly installed. (
)
page 7
❏
Check that the printer and battery are properly installed. (
)
page 7
Charge LED is flashing
❏
Turn the printer's power on. If the printer's Error LED stays unlit, the temperature is
outside the range that charging is possible in. Charge the printer at an ambient
temperature between 10 to 30°C {50 and 86°F}.
❏
If the printer's Error LED lights (when you turn the printer's power on), the battery is
faulty. Replace the battery with a new one.
8
U "Connecting the AC adapter" on
U "Charging the Printer" on