Ironing Without Steam - Bosch sensixx B10L Mode D'emploi

Cork HaNDlE IroN
(model dependent)
To get permanent steam, press the lock button
(14*) and slide it backwards until it locks.
To switch off the permanent steam, slide the lock
button forward.
Important:
• The steam hose may get hot if you are ironing
for long periods.

Ironing without steam

1. Set the required ironing temperature.
2. Begin ironing but without pressing the steam
release button (11).
4. vertical steam

See the leaflet sides
Never direct the steam jet at garments that
are being worn.
Never aim the steam at people or animals.
1. Set the temperature control to the "••" or "max"
position.
2. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by holding
the iron in a vertical position and pressing the
steam release button (11).
Operate the iron vertically at a distance of 10 to
20 cm
5. Cleaning the Boiler

See the leaflet sides
To extend the life of your steam generator and to
avoid any build up of scale, it is essential that you
rinse out the boiler after several hours of use
(approximately after 50 hours). If the water is
hard, increase the frequency.
Do not use descaling agents for rinsing out the
boiler, as they could damage it.
1. Check that the appliance is unplugged and cold
for more than 2 hours.
2. Unscrew the boiler´s cap (1)
3. Empty the boiler above a sink by holding the
appliance upside down.
4. Fill the boiler with 500 ml of fresh water.
5. Shake the base unit for a few moments and
then empty it completely over a sink or bucket.
6. To obtain the best result, we recommend that
this operation is done twice
7. Close the cap
6. rinsing the iron steam
chamber

See the leaflet sides
E
Caution! risk of burns!
This procedure helps to remove scale particles
out of the steam chamber.
This cleaning procedure may be performed
occasionally (approximately once a year), when
after a long period of use with very hard water,
cale particles start to come out of the soleplate.
a) Ensure that the iron is cooled down.
b) Set the temperature selector (10) of the iron to
the "min" position.
c) Fill the tank with tap water.
d) Plug in the mains cable and set the main
power switch (8) to the "I" position.
e) Wait until the "steam ready" indicator lamp (6)
lights up.
f) Hold the iron over the sink or a container to
collect the water.
g) Press the steam release button (11) and gently
shake the iron. Boiling water and steam will
come out, carrying scale and or deposits that
might be there. This could take approximately 5
minutes.
h) Set the temperature selector (10) of the iron to
the "max" position, without pressing the steam
release button (11). The water in the steam
chamber will start evaporating. Wait until all the
water inside the chamber has been evaporated.
i) To clean the soleplate, immediately rub off any
residue by running the hot iron over dry cotton
cloth.
7. Storing the appliance

See the leaflet sides
1. Set the main power to the "0" position and
disconnect the mains cable.
2. Always allow the appliance to cool down before
storing it.
3. Place the iron on the iron pad, standing on the
soleplate.
4. Empty the boiler and store the mains cable and
the steam hose in the storage compartment.
Do not wrap the cords too tight.
5. Use the carrying handles (16) on the sides
when moving the appliance.
15
BOS CH