Wireless Operation; Wired Operation - Lindy BNX-100 Mode D'emploi

Wireless Operation

Pairing
1. Switch on the Wireless function by pressing and holding the Multi-Function Button (7). If a not previously paired device is found
within range, the BNX-100s will automatically go into pairing mode and the LED indicator will alternately flash blue and red.
2. Enable the Bluetooth function on your mobile phone or tablet.
3. Navigate to the Bluetooth menu of your device and scan/search for new devices.
4. When the BNX-100s are found, select and follow the on screen prompts. If you are prompted for a passkey or pin-code, please use
0000.
5. You will see a notification on your portable device confirming that pairing and connection is complete.
6. The battery meter (3) will begin to flash to show that the BNX-100s are charging.
7. You can check the status of the battery using the battery meter (3), see below.
Please note: If during wireless use you are suffering from a delay between video and audio playback, this will be due to the
Bluetooth transmitter in your source device. To achieve a low latency, the source device's transmitter must also support aptX Low
Latency.
Re-pairing after connection
1. Enable the Bluetooth function on your device and ensure the BNX-100s are turned on.
2. If connection is not made automatically, go to the Bluetooth device list on your device and select BNX-100.
3. The device and BNX-100s will now be paired.
Disconnecting
1. To disconnect from the BNX-100s, press and hold the Multi-Function Button (7) until the LED Indicator is illuminated red.
2. Alternatively, to disconnect via the portable device, de-activate the Bluetooth function on your portable device.
Twin-Pairing Mode
The BNX-100s can be paired wirelessly with two separate Bluetooth devices simultaneously for uninterrupted audio switching or for
taking calls on one device while another is used for music.
1. Following the Pairing process above, pair with the first device.
2. While the first device is connected, switch on the Wireless function again by pressing and holding the Multi-Function Button (7).
While the LED blinks blue and red, connect the second device by selecting BNX-100 in your device's Bluetooth list.
3. As this will automatically un-pair the first device, re-connect by manually selecting BNX-100 in your source devices Bluetooth list.
The headphones do not need to be in pairing mode.
4. Both devices will now be connected to the headphones simultaneously. If the first device's audio is paused, the second device
will continue playing audio. If taking a phone call on the first device, please pause the second device and the headphones will
automatically connect to the first device.
Please note: If the audio quality is poor or a crackling noise can be heard, the Bluetooth connection is weak. Please ensure the device and
BNX-100s are within range of each other with no major obstacles.

Wired Operation

The BNX-100s can also be connected with a wired connection using the 3.5mm audio cable included with the headphones. This will also
prolong the battery life when using active noise cancelling. Please see the Technical Specifications section below for approximate battery
life times.
Wearing the BNX-100s
For a comfortable listening experience, the headband of the headphones can be adjusted easily by sliding upward or downward.
5