Preparations Before Installation - Hendi 222829 Mode D'emploi

Attachments

Preparations before installation

• Carefully unbolt the machine from the skid using
wrench if necessary.
• Remove all protective packaging and wrapping.
• Check the machine for completeness and trans-
port damages. In case of incomplete delivery (e.g.
Whisk, flat beater and dough hook) or damage,
Installation
• Read this manual thoroughly and carefully before
EN
installation and operation.
• Ensure the machine is placed in a dry area that
have sufficient strength surface to support with
no any obstruction during operation nearby.
• Ensure that the electrical power supply corre-
sponds with the rating label on the machine.
• There should have adequate space around the
machine for the operator to operate. It should be
Transportation and handling
• Do not move the machine while it is under op-
eration.
• Unplug the machine, remove the bowl (2) and all
attachments (whisk, flat beater or dough hook)
when moving the machine.
Special safety features
Attention: This machine has the following 3 safety switches. The machine only be started with all the safety
switches are at the proper positions
• Bowl position safety switch: The machine can be
started up once the bowl is positioned at the cor-
rect position.
• Bowl guard (5) safety switch: The machine can
only be started up once the bowl guard (5) is in
the closed position.
6
contact supplier immediately. DO NOT use the
machine. (See == > Warranty).
• Clean the machine and attachments before use
(See ==> Cleaning and Maintenance).
• Make sure the appliance is completely dry.
clean and free from obstructions, e.g. Nothing
placed on or around the machine, such as scrap-
ers, knives etc.
• Do not wear loose fitting clothing such as scarf,
etc and long hair should be tied up and keep away
from the moving parts.
CAUTION! Never bypass any safety switch.
• Hold the base of the machine (1) when moving to
have better support.
• With at least 2 people or using trolley for assis-
tance to move the machine due to heavy weight.
• Lift up lever (12) safety switch: The machine can
only be started up once the lift up lever (12) is
located in the upwards position.
Do not wear loose fitting clothing such as scarf, etc
and long hair should be tied up and keep away from
the moving parts