Safety Information - Salter MiBody Mode D'emploi

SAFETY INFORMATION

The below signs might be in the user manual, labeling or other components. They are the requirement of standard and
using.
Symbol for "THE OPERATION GUIDE
MUST BE READ"
Symbol for "COMPLIES WITH
0120
MDD 93/42/EEC REQUIREMENTS"
Symbol for "MANUFACTURER"
Symbol for "SERIAL NUMBER"
CAUTION
• Please do read this user manual carefully and thoroughly before use.
• This device is intended for adult use only.
• This device is intended for non-invasive measuring and monitoring of asterial blood pressure. It is not intended for
use on extremities other than the wrist or for functions other than obtaining a blood pressure measurement.
• Do not confuse self-monitoring with self-diagnosis. This unit allows you to monitor your blood pressure. Please
start or end medical treatment basing solely on physician's treatment advice.
• If you are taking medication, consult your physician to determine the most appropriate time for your measurement.
Never change a prescribed medication without your physician's consent.
• This unit is not suitable for continuous monitoring during medical emergencies or operations.
• If the pressure of the cuff exceeds 40 kPa (300 mmHg), the unit will automatically deflate. Should the cuff not
deflate when its pressure exceeds 40 kPa (300 mmHg), detach the cuff from the wrist and press the START/STOP
button to stop inflation.
• Do not use the monitor under the conditions of strong electromagnetic field (e.g. medical RF equipment) that
radiates interference signal or electrical fast transient / burst signal.
• The maximum temperature that the applied part can be achieved is 42.5ºC while the environmental temperature is
40ºC.
• The device is not AP/APG equipment. It is not suitable for use in the presence of a flammable anaesthetic mixture
with air (or oxygen, nitrous oxide).
• Please keep the unit out of reach of infants or children, since inhalation or swallowing of small parts is dangerous
or even fatal.
• Please use ACCESSORIES and detachable parts specified / authorised by MANUFACTURER. Otherwise, it may cause
damage to the unit or danger to the user / patient.
The Bluetooth Combination Mark
Symbol for "TYPE BF APPLIED PARTS"
Symbol for "ENVIRONMENT
PROTECTION - Wast electrical products
should not be disposed of with
household waste. Please recycle where
facilities exist. Check with your local
authority or retailer for recycling
advice"
Symbol for "DIRECT CURRENT"
3
GB