Samsung RF30KM Série Mode D'emploi page 18

( 4 ) The Fridge button serves two purposes:
Fridge/ - To set the Fridge to your desired
Power temperature.
Cool - To turn the Power Cool function on
(3sec) and off.
1) To set the Fridge temperature,
press the Fridge button. You can set the
temperature between 44 °F (7 °C) and
34 °F (1 °C).
2) Power Cool function
Touch and hold this button for 3 seconds
to decrease the time needed to cool
products in the Refrigerator. It can be
helpful if you need to quickly cool easily
spoiled items or if the temperature in
the fridge has warmed dramatically (for
example, if the door was left open).
( 5 ) The Lighting button serves two purposes:
Lighting/
- To turn the dispenser light on and off
ºC ↔ ºF - To switch the temperature units
(3sec)
between ºC and ºF
1) Light Function
Touching the Lighting button turns on the
Dispenser LED lamp in continuous mode
so that it stays on continuously.
The button also lights up. If you want the
Dispenser lamp to come on only when
some one uses the dispenser, press the
Lighting button to turn the continuous
mode off.
2) To switch the temperature units
between ºC and ºF
Touch and hold this button for 3 seconds
to select the temperature display you
want.
Each time you press and hold the button,
the ºC and ºF temperature modes
alternate and the ºC or ºF icon lights up,
indicating your selection.
18 English
RF30KMED_DA68-02894B-01_EN.indd 18
( 6 ) The Ice Maker Off button serves two
Ice Maker purposes:
Off/ - To turn the Ice maker on and off
Control - To turn the Control Lock Function on
Lock and off.
(3sec)
1) Ice Off Function
If you don't want to make more ice, press
the Ice Maker Off button.
2) Control Lock Function
Touch and hold this button for 3 seconds
to lock the display, the Flex Zone panel,
and the dispenser buttons so the buttons
can not be used.
When Control Lock is on, the refrigerator
does not dispense ice or water, even if the
Dispenser Lever is pressed.
The Control Lock icon lights up to
indicate you've activated the Control Lock
function. Press 3 seconds to unlock.
(7)
Touch this button to dispense water. This
Water
mode can not be used with the Ice Type
mode simultaneously.
Water mode shuts off when you touch the
Cubed/Crushed Ice button.
( 8 ) Water filter usage
Filter This icon lights up when you need
to change the filter, usually after the
refrigerator has dispensed about 300
gallons of water (after about 6 months).
The icon will blink red for several seconds
when you open or close the door.
After you install the new water filter, reset
the filter indicator by touching and holding
the Hold 3 sec for Filter Reset button for
3 seconds.
- If water is not dispensing or
dispensing slowly, you need to
replace the water filter because
the water filter is clogged.
- Some areas have large amounts
of lime in their water, which
causes the water filter to clog
more quickly.
( 9 )
Ice Type
Touch this button to select your desired
ice type. Cubed and crushed ice modes
alternate when you press the button. This
Cubed
mode can not be used with the Water
mode simultaneously.
Crushed
2016-03-30 12:56:06