Cleaning & Maintenance - NOSTALGIA PRODUCTS CBD5 Instructions

CLEANING & MAINTENANCE
1. After using your ON-TAP BEER GROWLER SYSTEM,
disconnect the unit from the electrical outlet.
2. Detach the Keg Lifter Assembly from the keg, then remove the keg from the Cooling Cavity.
3. Clean the Cooling Cavity.
a. Make sure there are no foreign objects in the Cooling Cavity.
b. Drain the water in the Cooling Cavity by placing the unit near the edge of a
table or countertop so that a bowl can be placed below the Drain Tab.
c. Place a bowl beneath the Drain Tab, then pull down on the Drain Tab to
allow the water in the Cooling Cavity to drain into the empty bowl.
d. Wipe the Cooling Cavity dry with a soft, non-abrasive cloth.
4. Clean the beer line using the included Cleaning Bottle.
a. Place an empty bowl beneath the Tap Faucet.
b. Load the Cleaning Bottle with warm, soapy water.
c. Insert the tip of the Cleaning Bottle into the open end of
the Dip Tube (part of the Keg Lifter Assembly).
d. Pull down on the Tap Handle, then squeeze the Cleaning Bottle to allow the
soapy water to flow through the beer line and into the empty bowl.
e. Repeat this process with just warm water as many times as necessary until
the beer lines are clean and all soap is cleared from the beer line.
f. If the Beer Line needs to be replaced, lift up on the Beer Line and chrome
plate covering the line. Pull down on the Tap Handle, then pull on the old
Beer Line to remove. The new Beer Line can be put back into place by again
pulling down on the Tap Handle, then inserting the Beer Line into the tap.
Releasing the Tap Handle will pinch the new Beer Line, securing it.
5. Wash the remaining removable parts in warm, soapy
water. Dry with a soft, non-abrasive cloth.
6. As needed, wipe down the exterior of the unit with a damp, non-abrasive cloth.
13