Oster 78005 Mode D'emploi page 3

When sharpening blades becomes necessary,
send blades to an Authorized Service Center
where approved methods, equipment and
proper knowledge are used to restore the
original hollow-ground design and best cutting
ability. Sharpening blades by flat grinding or any
method contrary to the design and construction
of Oster cutting blades is not recommended.
™
REMOVING OR REPLACING BLADES
TO REMOVE:
IMPORTANT! STOP
MOTOR; lift blade away
from clipper and slide of
tongue.
TO REPLACE:
Turn motor on; insert
blade on tongue fully
then snap blade into
place.
LUBRICATING THE BLADES
A light film of oil should be maintained on
the surface of the cutting blades. Oiling the
blades frequently while in use will help keep
the blades cleaner. Clean blades cut better. To
clean blades, dip the teeth into Oster ™ Blade
Wash cleaner with the clipper running. DO NOT
IMMERSE THE CLIPPER. Remove from the
mixture and, while holding the clipper with the
blade end down, wipe the blades dry with a
clean, dry cloth. Re-oil blades.
WARRANTY INFORMATION
SERVICING OF A DOUBLE INSULATED
APPLIANCE
In a double insulated appliance, two systems
of insulation are provided instead of grounding.
No grounding means is provided on a double-
insulated appliance, nor should a means for
grounding be added. Servicing a double-
insulated appliance requires extreme care and
knowledge of the system and should be done
only by qualified service personnel.
Replacement parts must be identical to those
parts being replaced.
A double-insulated appliance is marked
with the words "DOUBLE INSULATION" or
"DOUBLE INSULATED" The symbol may also
be marked on the appliance.
MAINTENANCE AND STORAGE
NOTE: Any other maintenance not explained
in this manual should be performed by an
Authorized Service Center. To store unit, coil and
place in original carton.
When using or cleaning this clipper, do
not use any aerosol sprays or blade
washes, especially those containing
methylene chloride, dimethyl benzyl
ammonium chloride, or 1-1-1
trichloroethylene. Damage caused by these
chemicals will void your warranty. You may use
Oster Blade Wash, Oster Blade Lube and
™ ™
Oster 5 in 1 Clipper Blade Care which do not
™
harm the product.
Disposal in E.U. countries
Do not dispose of the appliance with
domestic refuse. As part of the E.U.
Directive governing the disposal of
electric and electronic appliances, the
appliance is accepted free of charge
by local waste collection points or
recycling centers. Correct disposal will ensure
environment protection and prevent a potential
harmful impact on people and the environment.
Disposal in non-E.U. countries
Please dispose of the appliance at the end
of service life in an environmentally friendly
manner, per applicable local and national laws
and regulations.
SERVICE INFORMATION
How and Where to Get Service
INFORMATION • DO NOT DESTROY • READ
CAREFULLY
The foundation of our business has been built
upon the principle of service to the user, both in
designing superior products and in keeping them
in condition to give long-lasting use. That is why
we back up our reputation for manufacturing top-
quality products by providing the finest service
facilities possible for adjustment and repairs,
when necessary. Please retain the original
packaging materials and carton, if possible, to
facilitate the packaging of the product if service
is required.
- 4 -
HOW TO GET SERVICE WHEN YOU
NEED IT
To locate your closest distributor, please go to:
WWW.OSTERPRO.COM
1. Once you have located a Service Station,
take your product there. To make packaging
the product easier, use the original
packaging materials and carton if you have
them.
2. If it is necessary to ship the unit to the
Service Station:
a. Pack it carefully in a good carton with
plenty of crumpled paper or other padding
around it. Tape or tie the carton securely.
b. The warranty does not cover damage in
transit. Carefully address the package to
the nearest Service Station. Don't forget
your name and return address, including
postal zip code.
c. Your Post Office will tell you the proper
amount of postage and can insure the
package against loss.
3. If returning a clipper, include blades.
4. When ordering Parts or Accessories specify
the Service number (or Model No. and the
Series Letter) indicated on your product.
LIMITED WARRANTY
This product is warranted for one year from
date of purchase to be free of mechanical and
electrical defects in material and workmanship.
The manufacturer's obligation hereunder is
limited to repairing such products during the
warranty period, provided the product is sent
prepaid to an Authorized Service Station. This
warranty does not cover normal wear of parts
or damage resulting from any of the following:
Negligent use or misuse of the product, normal
wear and tear, damage, Acts of God, use
on improper voltage or current, use contrary
to operating instructions, or disassembly,
repair or alteration by any person other than
an Authorized Service Station. All warranties
and implied warranties on Oster clippers are
™
considered null and void if product failures occur
as a result of using after market components,
such as gear train components, levers,
unsuitable blades, electric power boosters and
other such components and devices. Return
of the Owner Registration Card is not required
for warranty coverage. This warranty gives you
specific legal rights and you may also have other
rights which vary from state to state, province to
province or jurisdiction to jurisdiction. No other
warranty is provided and to the extent prohibited
by applicable law, any implied warranty of
merchantability or fitness for a particular purpose
is limited to the duration of this warranty and the
company shall not be responsible for incidental
or consequential damages.
If your appliance includes a country-specific
guarantee or warranty insert please refer to
the terms and conditions of such guarantee
or warranty in place of this guarantee or
contact your local authorized dealer for more
information.
In accordance with the European Directives
on Low Voltage (73/23/EEC as amended by
93/68/EEC) and Electromagnetic Compatibility
(89/336/EEC as amended by 93/68/EEC), the
CE-marking has been affixed on the equipment.
The following importer and distributor keeps
the conformity declaration on file: Oster GmbH,
Am Eisernen Steg 20, D-65795 Hattersheim am
Main, Germany, info@oster-europe.com, phone
+49 (0) 6190-93443-0.
- 5 -