RECARO Polaric Mode D'emploi page 6

Table des Matières

Publicité

Kapitel 1
– Einbau / Ausbau
Chapter 1
– Installation / Removal
Ziehen Sie an den freien Enden der Spanngurte kräftig nach
unten, bis diese straff gespannt sind und kontrollieren Sie
diese Spannung nach jedem Verstellen des Vordersitzes.
Pull the free ends of the belts firmly downwards until they
are tight. Check this tension whenever the front seat is
readjusted.
1.10 - 1.11 Ausbau des Sitzes
Drücken Sie die roten Tasten an den Spanngurten, dann
öffnet sich das Gurtschloss.
1.10 - 1.11 Removing the seat
Press the red buttons on the belts so as to open the buckle.
Bewegen Sie beide Schieber an den Isofixkonnektoren in
Pfeilrichtung (Bild 1.11), bis sich die Verrastung löst. Jetzt
können Sie die Konnektoren aus den Einführhilfen ziehen.
Push the two sliders on the Isofix connectors in the direction
of the arrow (Fig. 1.11) until they are disengaged. Now you
can pull the connectors out of the guides.
D
GB
1.9
1.10
1.11
5123-4-06/1
5114F-4-02/1
5116F-4-02/1
5117F-4-00/1

Publicité

Table des Matières
loading

Table des Matières