Drum Clean - Hoover HWPD 21 Mode D'emploi

Pressing the CARE DOSE button you will

be able to set the autodose function,
according to your needs.
If you want to change the factory settings,

press CARE DOSE button. Afterward,
you can choose the desired setting:
- Pressing once the CARE DOSE button,
the ONLY softener autodose will be
deselected.
- Pressing twice the CARE DOSE button,
both the detergent and softener autodose
will be deselected.
- Pressing three times the CARE DOSE
button, the ONLY detergent autodose
will be deselected.
- Pressing four times the CARE DOSE
button to go back to the factory settings
(both the detergent
autodose are ON).
WARNING:
It is necessary to clean the drawer
every time it is filled or the type of
detergent and softener is changed.
The drawer MUST REMAIN CLOSED
during the entire
otherwise the dosing may not work
properly or water may leak.
SPECIAL PROGRAMMES button
This button allows you to choose between
three different options (available for some
programmes only):
- ACTIVE WASH
This option (which can be set in several

programs) optimizes
energy consumption of the selected
program, maintaining
performance unchanged.
and softener
wash cycle,
the water and
the washing
75
ACTIVE WASH is designed for reduced

loads and lightly soiled garments, aiming
to limit the unnecessary waste.
- NIGHT & DAY
This option reduces the intermediate spin

speed to 400 rpm, where applicable,
increase the water level during rinsing
and keep the laundry immersed in water
after the final rinse, in order to spread the
fiber perfectly.
During the drum water retention phase,

the machine is in pause mode.
Press START to end the cycle with the

spin (which can be reduced or removed
with the specific button) and drain phase.
Thanks to electronic control, the water in

the intermediate phases is
silently, making this option very useful for
washing at night.

- DRUM CLEAN

Developed to clean the washing machine

drum.
Use only powder detergent.

Do not start the programme with laundry

in the washing machine.
It is suggested that this is carried out after

every 50 washing cycles.
The option can only be selected for the

DRAIN & SPIN programme.
These options
before pressing the START/PAUSE
button.
If an option is selected that is not
compatible with
programme then the option indicator
light first flashes and then goes off.
emptied
must be selected
the selected