RS Pro ESM-3712-CN Manuel D'instructions page 14

6.4 Entering To The Programming Mode, Changing and Saving Parameter
Main Operating Screen
O O
C F
When SET button is pressed for 5
seconds, "P" led starts to blink. If
programming mode entering
password is different from 0,
programming mode entering screen
will be observed.
O O
C F
Password Entering Screen
Enter programming mode accessing
password with increment and decrement
Note-2: If programming mode accessing password is 0 parameter values can be seen.But
parameter values can not be changed.
Programming Screen
O O
C F
Press SET button for accessing to the parameter
value. Press increment button for accessing to
the next parameter, press decrement button for
accessing to the previous parameter
O O
C
F
Compressor Output
Hysteresis Parameter Value
Press set button for saving
the parameter.
i
If no operation is performed in programming mode for 20 seconds, device turns to main
operation screen automatically..
7. Failure Messages in ESM-3712-CN Cooling Controller
1- message blinking
no sensor connection. While this message shown on this display, if buzzer function selection
parameter is 3 or 4, internal buzzer starts to operate.
ESM-3712CN
S P
ü
Note1: If programming mode
accessing password is 0,
Temperature Unit Selection
Screen
instead of programming
screen accessing password
ESM-3712CN
S P
ü
ESM-3712CN
S P
ü
ESM-3712CN
S P
ü
.Cabinet temperature sensor failure
O
C
Programming Mode
Entering Screen
Press SET button for
is observed
accessing to the
password entering screen.
O
C
Password Entering Screen
Press SET/OK button for
entering the password.
O
C
Compressor Output
Hysteresis Parameter Value
Change the value with increment
and decrement buttons.
O
C
Compressor Output
Hysteresis Parameter
Press increment button for accessing to the
next parameter, press decrement button for
accessing to the previous parameter
. S ensor connection is wrong or there is
ESM-3712CN
O
F S P
ü
ESM-3712CN
O
F S P
ü
ESM-3712CN
O
F S P
ü
ESM-3712CN
O
S P
F
ü
14