Placing In Service; Changing The Bulb - Pontec PONDOSTAR 20 Mode D'emploi

GB

Placing in service

1. Connect the safety transformer at a location where it is dry and cannot be flooded.
The transformer must have at least 2 m clearance to the edge of the pond.
2. Place the halogen spotlight in the pond or next to the pond. Anchor the light
pedestal to a stable base or weight it with rocks to achieve a stable position of the
pond light, and to prevent floating.
3. Layout the power cord and connect it to the safety transformer.
Caution!
The halogen spotlight heats up in normal operation. Only touch the hot light
fixture on the reflector screen or on the screw ring.

Changing the bulb

1. Disconnect the light or the safety
transformer from the mains power and
secure it from being switched on
unintentionally.
2. Dry off the halogen spotlight.
3. Unscrew the screw ring (5) from the bulb
housing (1).
4. Remove the protective glass (4) and the
flat seal (3).
5. Take bulb (2) out of its mounting and
replace it.
Caution! Do not touch the bulb
directly with your hand as this
significantly reduces the service life
of the bulb. Use a piece of paper or a
soft cloth to replace the bulb.
6. The power consumption on the bulb and
that on the nameplate must agree.
7. Replace the flat seal (3) and the protective
glass (4).
8. Screw the screw ring (5) onto the bulb
housing (1).
Directions for use
GB
5
4
3
2
1
9