Waste Electrical And Electronic Equipment - babymoov Hygro A047012 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1

• Waste Electrical and Electronic Equipment

should be disposed of by selective
collection. Do not throw electrical and
electronic equipment away with un-sorted
household waste, but dispose of it at a
selective collection point.
a. Air output
b. Water capacity
c. Water level sensor
d. Transducer
Please read these instructions carefully before switching the humidifier on. Please install the humidifier
on a flat surface well out of the reach of children.
Fill the water reservoir
1.Remove the reservoir from the humidifier base (diagram 1). Turn the water reservoir upside down.
2. Unscrew the filling plug (diagram 2).
3. Fill the water reservoir with tap water or distilled water (diagram 3).
4. Screw the filling plug in firmly (diagram 4).
5. Refit the reservoir on the main casing (diagram 5). Wait a few seconds for the humidifier base to fill with water.
Using the humidifier
6. Connect the supply lead to the mains (diagram 6). Turn the setting button to MAX .
Adjust the humidifier intensity to the desired setting:
- OFF = low intensity,
- MAX = high intensity.
Make sure that the vapour output is not facing walls, sockets or furniture.
Emptying the humidifier
7. Switch the humidifier off by turning to OFF and unplugging the appliance (diagram 7). The indicator light
must be off. Disconnect the appliance, remove the water reservoir from its base.
8. Empty the water from the base (diagram 8). Next, wipe off any remaining drops with a soft cloth.
If the humidifier does not work, you should check that:
- the lead is connected to the power socket,
- the vapour intensity control switch is working,
- the water reservoir has been replaced correctly on the base,
- there is sufficient water in the reservoir.
• Before cleaning, always unplug the humidifier and make sure that it has cooled down.
• You can clean the humidifier simply using a soft and slightly damp cloth or sponge. Leave it to dry naturally.
Never immerse the base in water or any other liquid.
• Clean the water reservoir regularly (using a swab for example). Use a mixture of water and bleach to clean the
water reservoir. Rinse with clean water, and leave to dry naturally. Never use detergent to clean any part of
the humidifier that is designed to hold water. A cloud of detergent dissolved in water could interfere with your
humidifier's vaporisation function.
• Never use stripper, solvent or any abrasive substance for cleaning: they would risk damaging your humidifier
and its walls.
• Before putting your humidifier away, empty the water reservoir and also empty out any water remaining in the
main casing. Make sure that all parts are absolutely dry. Leave the plug unscrewed to prevent the seal
sticking to the reservoir.
COMPOSITION
e. Base
f. Vapour flow adjustment
g. Minimum humidity setting
h. Filling plug
INSTRUCTIONS
MAINTENANCE
HYGRO • Instruction Manual
• This marking indicates that this
product should not be disposed with
other household wastes throughout
the EU.
i. Water reservoir
J. Emptying tube
k. Air output
7

Publicité

Table des Matières
loading

Table des Matières