ALPATEC F 10 FC Notice D'utilisation page 12

Notice F 10 FC:Notice Fontaines
1- LOADING THE DISPENSER
• Make sure the dispenser is unplugged with both the hot and cold power switched off.
• Wash hands and wipe the adaptor and the top of the bottle with a clean cloth.
• Avoid touching the part of the bottle and adaptor that will be in contact with the water dispenser.
• Make sure the water level in the top of the dispenser is low enough to allow for proper bottle installation.
Failure to do so may cause the dispenser to overflow.
• Please refer to "care and cleaning of the dispenser" for using the water dispenser for the first time or after
its maintenance.
- Remove the cover on the bottle.
- Use the correct adaptor (13) or (14) (part
16 closed) inside the bottle and screw.
- Remove the dust protection stopper (15)
from adaptor and put the bottle with
adaptor into the top cup from the water
dispenser.
2- BEFORE USING
Press the hot water and cold water pushbuttons together until water is flowing out.
3-USING
Plug the appliance.
Switch on the appliance (switches on are on the back of the water dispenser (7) and/or (8).
COLD WATER:
- If you switch on the cooling water switch, cool light indicator lights on in orange. Ventilation and cooling
process starts. You can use the water dispenser but water will be not at < 15 ° C temperature. When cool-
ing process will be finished, cool light indicator lights off.
Press corresponding button cold water (5) to fill the glass with water.
HOT WATER:
- If you switch on the heating water switch, heating light indicator lights on in red.
Heating process starts. When temperature reaches 90°C, heating light indicator switches off and hot light
indicator lights on in green. When temperature of hot water into the tank is not enough hot, hot light indica-
tor will switch off and heating light indicator will switch on again (to restart heating process).
9/12/09 14:10 Page 12
USING
USING
12