Samson Graphite 49 Mode D'emploi page 25

Graphite 49 · USB/MIDI Keyboard Controller
Performance Controls
of the button is a note type, press the button to send note on message and release the button to
send a note off message.
The button number and value will be shown in the Operation and Data area of the display, and
the port, channel, button type, button mode and note number or control code information will
be shown under relevant tags. The function of each button is assignable. You can change param-
eters or assign other controls to buttons through the setup function. Please refer to Setup Mode
(p. 17) for details. The factory default settings for the function buttons are listed in the Factory
Default Setting table on p. 31.
Transport Buttons
There are five transport buttons marked
Rewind, Fast Forward, Stop, Play and Record, respectively. Please see detailed information for the
default settings in the table below.
Component Category
Transport
Button
The function of each button is assignable. You can change parameters or assign other controls to
these buttons through the setup function. Please refer to Setup Mode (p. 17) for details.
During performance, if a note is stuck on, press the Rewind and Fast Forward buttons simultane-
ously, and the unit will send Panic command to all ports and channels of external sound, causing
the device to terminate the sound. The Panic command includes "all notes off, " "reset all control-
lers, " "reset pitch bend" and "reset GM" system messages. During the panic processing, "PANIC" will
appear in the Operation area of the display.
Note: Not all sound generating devices support this Panic command.
Description Port Message
Rewind - CC: 116, Ch -
Fast Forward - CC: 117, Ch -
Stop - CC: 118, Ch -
Play - CC: 119, Ch -
Record - CC: 114, Ch -
. The factory default settings are to
Transmitted Data (H)
B0 74 7F/00
B0 75 7F/00
B0 76 7F/00
B0 77 7F/00
B0 72 7F/00
Type Mode
C T
C T
C T
C T
C T
25