Vision TM-ST TECHMOUNT Mode D'emploi page 6

4. Fit section 1 of the boom to the wall plate, and fix tightly using the two pin-hex
bolts included.
5. Fit the universal "spider" fitting included to the projector as shown by threading the
43mm screws included through the hollow screw already in place on each "leg" of
the spider.
6. For Hitachi CP-A100 / ED-A111 / CP-A52 / CP-D10 / CP-DW10N and Ultra-Short-
Throw projectors attach the spider/projector assembly to section 2 of the boom.
Section 2 of boom
For Hitachi CP-AW100N and Short-Throw projectors attach the spider/projector
assembly to the tilting mechanism, then attach all to section 2 of the boom.
WARNiNG: Using the tilting mechanism
with CP-A100, CP-A52 and ED-A111 and
other Ultra-Short-Throw projectors is not
recommended as it may cause image distortion.
4
Section 1 of boom
1. Universal "Spider" Fitting
2. Projector