Leak Testing - Nexgrill 720-0830XA Instructions D'opération

GENERAL
Although all gas connections on the grill are leak tested at
the factory prior to shipment, a complete gas leak test check
must be performed at the installation site due to possible
mishandling in shipment, or excessive pressure
unknowingly being applied to the unit. Periodically check the
whole system for leaks following the procedures listed
below. If the smell of gas is detected at anytime you should
immediately check the entire system for leaks.
It's recommended to use the regulator complied with EN
16129:2013.
The flexible hose should approved by EN 16436:2014.
As of category I , the gas type and outlet pressure of
3B/P(30)
the regulator is: butane/propane 30 mbar;
Category I , should be: butane 28-30 mbar or
3+(28-30/37)
propane 37 mbar; I , butane/propane 37 mbar; I
3B/P(37)
butane/propane 50 mbar.
BEFORE TESTING
Make sure that all packing material is removed from the grill
including tie-down straps.
DO NOT SMOKE WHILE LEAK TESTING.
NEVER PERFORM LEAK TEST WITH AN OPEN FLAME.
Make a soap solution of one part liquid detergent and one
part water. You will need a spray bottle, brush, or rag to
apply the solution to the fittings. For the initial leak test,
make sure the LPG cylinder is 80% full.
TO TEST
Make sure the control valves are in the "○" position,
1.
and turn on the gas supply.
2. Check all connections from the LPG gas regulator and
supply valve up to and including the connection to the
manifold pipe assembly (the pipe that goes to the
burners). Soap bubbles will appear where a leak is
present.
3. If a leak is present, immediately turn off the gas supply
and tighten the leaky fittings.
4. Turn the gas back on and recheck.
5. Should the gas continue to leak from any of the fittings,
turn off the gas supply and contact Customer Service at
+4562206336 or email ServiceDK@nexgrill.com
Only those parts recommended by the manufacturer should
be used on the grill.
Substitution will void the warranty. Do not use the grill until
all connections have been checked and do not leak.
GAS FLOW CHECK
Each grill burner is tested and adjusted at the factory prior
to shipment; however, variations in the local gas supply may
make it necessary to adjust the burners. The flames of the
burners should be visually checked.
Flames should be blue and stable with no yellow tips,
excessive noise or lifting. If any of these conditions exist,
check to see if the air shutter or burner ports are blocked by
dirt, debris, spider webs, etc. If you have any questions
regarding flame stability, please call customer service at
+4562206336 or email ServiceDK@nexgrill.com
ALWAYS CHECK FOR LEAKS AFTER EVERY
LPG TANK CHANGE
Check all gas supply fittings for leaks before
,
3B/P(50)
each use. It is handy to keep a spray bottle of
soapy water near the shut-off valve of the gas
supply line. Spray all the fittings. Bubbles
indicate leaks.
Place dust cap on cylinder valve outlet when the
cylinder is not in use. Only install the type of dust
cap on the cylinder valve outlet that is provided
with the cylinder valve. Other types of caps or
plugs may result in leakage of LPG.
The gas must be turned off at the supply cylinder
when the unit is not in use.
If the appliance is stored indoors the cylinder
must be disconnected and removed from the
appliance. Cylinders must be stored outdoors in
a well-ventilated area out of the reach of children.
9
CAUTIONS
Your grill is ready to use!

Leak Testing