Kozy Heat Fireplaces HTK-EXT 101 Mode D'emploi page 10

11. Lay the band clamp over the 6" collar as shown in Figure 2.12.
Attach the inside 6" liner to the collar with (3) sheet metal screws.
Use the band clamp to attach the outer insulated liner over the
top of the inner liner to the collar. See Figure 2.13.
12. Cut insulated flex pipe to desired length to reach from the collar
on the air chute to the collar on the exterior heat transfer kit.
13. Slide the band clamp over the remaining unattached insulated
liner. Use (3) sheet metal screws to attach the inner liner to the
HTK-EXT. See Figure 2.14.
14. Secure flexible pipe. Support the duct at intervals of no greater
than 4 feet.
15. Run the wiring into the #HTK-EXT. See Section 3.0 on page 11.
16. After you complete the necessary wiring, reinstall the cover
assembly using (6) screws previously removed.
17. Use (3) provided screws to attach the vinyl siding shield. See
Figure 2.15.
Figure 2.12, Band Clamp
Figure 2.13, Screws in Inner Liner
10
Figure 2.14, Liner Installed with Band Clamp
Figure 2.15, Vinyl Siding Installed
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces Heat Transfer Kit - Exterior #HTK-EXT R.5