Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ELECTRICAL
W A R N I N G
THIS LAWN TOOL IS FOR OUTDOOR USE ONLY. DO NOT EXPOSE TO RAIN OR USE IN
DAMP LOCATIONS.
GUIDELINES FOR USING EXTENSION CORDS
USE THE PROPER EXTENSION CORD. Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one of heavy enough gauge to carry the current
your product will draw. An undersized cord will cause overheating. The table below shows the
correct size to use depending on cord length and nameplate ampere rating. If in doubt, use the
next heavier gauge.The smaller the gauge number, the heavier the cord.
MINIMUM GAUGE FOR EXTENSION CORDS (AWG)
Amp Rating
More Than
Not More Than
0
6
10
12
Be sure your extension cord is properly wired and in good condition. Always replace a damaged
cords away from sharp objects, excessive heat and damp or wet areas.
Use a separate electrical circuit for your tools. This circuit must not be less than 12-gauge cord
and should be protected with a 15-amp time delayed fuse. Before connecting the motor to the
power line, make sure the switch is in the OFF position and the electric current is rated the same
as the current stamped on the motor nameplate. Running at a lower voltage will damage the
motor.
W A R N I N G
THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM
ELECTRICAL SHOCK.
(WHEN USING 120 V ONLY)
25' (7.6 m)
6
18
10
18
12
16
16
14
SAVE THESE INSTRUCTIONS
Total Length of Cord in Feet (meters)
50' (15 m)
16
16
16
12
11
100' (30.4 m)
150' (45.7 m)
16
14
14
Not Recommended
14
12
12
Publicité
Table des Matières
