Master FS 60 Mode D'emploi page 9

IMPORTANT: Assemble the fan completely be-
fore commissioning (FIG. 2).
3. OPERATION
IMPORTANT: READ, UNDERSTAND AND FOL-
LOW THE "SAFETY INFORMATION" BEFORE
STARTING THE FAN IN ORDER TO USE IT
CORRECTLY AND AVOID RISKS.
►►3.1. SWITCHING THE FAN ON:
►3.1.1. Plug the fan into the mains (make
sure the power cable is intact and the mains
features match those on the fan's rating plate).
►3.1.2. Adjust the height and inclination of the
fan head (FIG. 3-4).
►3.1.3. Turn the "ON/OFF" switch to "ON" (FIG.
5) [I: Minimum Power] - [II: Maximum Power].
NOTES: Lifting or lowering the lever on the fan
head, activates or deactivates the automatic
rotation (FIG. 6).
►►3.2. SWITCHING THE FAN OFF:
►3.2.1. Turn the "ON/OFF" switch to "OFF" (0)
(FIG. 5).
►3.2.2. Unplug the fan from the mains.
NOTE: DO NOT UNPLUG THE FAN FROM
THE MAINS TO SWITCH IT OFF.
6. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE
The fan does 1. "ON/OFF" switch on "OFF" (0)
not switch on 2. No power supply
3. No electricity
4. Faulty electronics
5. Fan blocked
Reduced 1. Faulty electronics
airflow 2. Foreign substance obstructing
the airflow
4. STORAGE
Always unplug the fan from the mains when
not in use and before storing it. Put the fan in
a dry place protected from dust. When the fan
is used again, check the condition of the power
cable. If in doubt regarding its state, contact the
technical support centre. In any case, ask the
technical support centre to check that the fan is
working properly at least once a year and/or as
required.
5. MAINTENANCE
EXTENSIVE MAINTENANCE OR REPAIR OF
THE FAN MUST BE CARRIED OUT BY THE
TECHNICAL SUPPORT CENTRE.
Before performing any maintenance or repair,
disconnect the power cable from the mains. An
accumulation of dust and dirt inside the fan's
grille can cause a decrease in performance;
it is important to always keep the appliance in
excellent condition to ensure safe and proper
operation. Cleaning the fan's grille and external
structure are the only maintenance activities
allowed. Only use high pressure air and a soft
cloth to clean. The fan must never be cleaned
using water or solvents of any kind.
POSSIBLE SOLUTION
1. Turn the "ON/OFF" switch to "ON" (I - II)
2A. Plug the power cable into the mains socket
2B. Contact a technical support centre
3. Restore the electricity supply
4. Contact a technical support centre
5. Contact a technical support centre
1. Contact a technical support centre
2A. Remove any obstructions
2B. Contact a technical support centre
en
it
de
es
fr
nl
pt
da
fi
no
sv
pl
ru
cs
hu
sl
tr
hr
lt
lv
et
ro
sk
bg
uk
bs
el
zh