Install Duct Covers - Jennair W10692910 Instructions D'installation Et Guide D'utilisation Et D'entretien

4. Run home power supply cable through strain relief and into
the terminal box.
A
C
D
E
A. Home power supply cable
B. UL listed or CSA approved
strain relief
C. Black wires
5. Use UL listed wire connectors and connect black wires (C)
together.
6. Use UL listed wire connectors and connect white wires (E)
together.
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
Failure to do so can result in death or electrical shock.
7. Connect green (or bare) ground wire from home power
supply to yellow-green ground wire (F) in terminal box using
UL listed wire connectors.
8. Tighten strain relief screw.
9. Install terminal box cover.
10. Check that all light bulbs are secure in their sockets.
11. Reconnect power.
Optional Power Cord Kit Installations
For optional power cord kit installations, follow the instructions
supplied with the power cord kit. See the "Assistance or
Service" section for information on ordering.
NOTE: Use only with range hood cord connection kits that have
been investigated and found acceptable for use with this model
range hood.
10
B
F
D. UL listed wire connectors
E. White wires
F. Green (or bare) and yellow-
green ground wires

Install Duct Covers

NOTE: Remove the film from the duct covers.
1. Assemble the upper duct covers together, and then install
the duct covers around the support frame. The larger hole
in the flanges of the upper duct cover must be outside the
smaller hole in the mating flange of the other upper duct
cover.
2. Secure the upper duct covers together with two 3.5 x 6.5
mm screws at the top and two 2.9 x 3 mm screws at the
bottom. Install 1 screw on each side at the top and bottom of
the assembled duct covers.
A
C
A. 3.5 x 6.5 mm screws (2)
B. Assembly holes (larger hole outside of
smaller hole on both sides)
C. 2.9 x 3 mm screws (2)
NOTE: For non-vented (recirculating) installation, the slotted
holes in the upper duct covers will be visible when assembled.
For vented installations, the slotted holes will be hidden down
inside the lower duct covers.
B
A. Top toward ceiling
B. Slots installed up for non-vented installations
C. Slots installed down for vented installations
B
A
C
A
C