Replacing Lamps - Gorenje BHP923E13X Mode D'emploi

OPERATION
Use the high suction speed in cases of concentrated kitchen vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately
after terminating cooking.
MAINTENANCE
ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switch-
ing off at the connector and removing the connector fuse.
Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.
Cleaning
The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of
the fat fi lters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the fi lters may
cause fi re risks. Therefore, we recommend observing these instructions. The manufacturer declines all responsibility for
any damage to the motor or any fi re damage linked to inappropriate maintenance or failure to observe the above safety
recommendations.
Grease fi lter
Traps cooking grease particles. The grease fi lter must be cleaned once a month using non aggressive detergents, either
by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the
grease fi lter may discolour slightly, but this does not affect its fi ltering capacity. To remove the grease fi lter, pull the spring
release handle.
Charcoal fi lter
(fi lter version only)
It absorbs unpleasant odours caused by cooking. The saturation of the charcoal fi lter occurs after more or less prolonged
use, depending on the type of cooking and the regularity of cleaning of the grease fi lter. In any case it is necessary to replace
the cartridge at least every four mounths. The charcoal fi lter may NOT be washed or regenerated.

Replacing lamps

The hood is equipped with a lighting system based on LED technology. The LEDs guarantee an optimum lighting, a duration
up to 10 times as long as the traditional lamps and allow to save 90% electrical energy.
For replacement, contact the technical service.
28
1. The motor is ON/The motor is OFF
If you press the button when the ventilation hood in operation, the appliance is OFF
2. 2,3 increase of the speed
If you press the button the hood is ON and takes the speed 1
If you press the button (the hood is ON) the speed of the motor increases from 1 to more
intensive
Speed 1:1
Speed 2:2
Speed 3:3
3. Lights are ON/OFF