ConStands MidLift XL Mode D'emploi page 5

Step 1
Mount the lifting cylinder (B) on the two mounting
points. Use pre-assembled screw M16 x 65 and nut
for the upper mounting point. Use pre-assembled bolt
with washer and safety split pin for the lower
mounting point.
Step 3
Vent the lifting cylinder. Slightly open the breather
screw. Press the foot pedal until some hydraulic oil leaks.
Close vent screw. Release foot pedal.
MONTAGE
Schritt 2
Install the foot pedal on the lifting cylinder and fix it
with the M8 x 30 screw.
EN
Seite 3 von 3
Page 3 of 3