Publicité
Les langues disponibles
Les langues disponibles
To start the device, press the "
" button on the control panel or on the remote
control. The fan heater now starts to emit cold air. Press the "
" and the "
"
button to adjust the desired temperature. The display shows the temperature. The
heater will start heating if the set temperature is higher than the room tempera-
ture. The symbol "
" is displayed. The fan heater has 2 heat settings. Heat setting
2 is enabled if two "
" symbols are displayed.
You can also manually configure if you want to enable heat setting 2 or heat setting
1. To do this, press the "
" symbol on the control panel.
6. Remote control
Use a CR2025 3V battery for the remote control. All the functions that can be
performed using the remote control have the same function as those on the
control panel of the fan.
7. Oscillation
To turn the oscillation on or off, press the "
" button on the control panel at
the top of the fan or on the remote control.
8. Timer function
You can enable the timer function by pressing the "
" button. The currently
configured timer stage is displayed. You can select between 0 to 8 hours.
9. Tilt protection
Thanks to the tilt protection at the bottom of the device, it switches off automat-
ically if the device tilts over. The fan heater can therefore be placed on even and
flat surfaces only.
10. Overheating
WARNING: To avoid overheating, the heater should not be covered.
Overheating generally occurs only if one of the openings of the fan heater is
covered, blocked or clogged. This device has overheating protection. The heater
switches off automatically once the overheating temperature is reached. If the
device is therefore turned off for this reason, disconnect the plug and wait for 30
minutes. You can then attempt to turn on the device once again. If this does not
happen, please contact the customer service department.
22
English
Publicité
