Pre-Installation Checks - Mitsubishi Electric Jet Towel JT-MC106G-W-NA Manuel D'installation

Pre-installation checks

Warning
⚫
Input Power: 120 Vac Single-phase
Using the incorrect power supply may cause fi res, electric shocks or malfunctions.
■ Checking the installation environment
Do not install the unit in the following types of locations.
(This may cause malfunctions.)
⚫ Outdoors ⚫ Locations where the temperature could be lower than 32 F (0 C).
⚫ Locations where there is a lot of dust. ⚫ Locations where the temperature could be higher than 104 F (40 C).
⚫ Locations where there is a lot of condensation. ⚫ Locations where salt damage may occur.
⚫ Locations where the unit is in direct or strong sunlight (may cause the sensor to malfunction).
⚫ In vehicles (including ships and airplanes)
⚫ Locations where corrosive, neutral or reductive gasses are present.
(This may shorten the working life of the unit and/or cause malfunctions.)
⚫ Near food or tableware ⚫ Locations where the unit may come into direct contact with water.
⚫ Kitchens
(Where there is a risk of water splashing.)
⚫ Rooms that have a sterilization basin, swimming pools and baths.
■ Checking the unit, accessories and items required for installation
Unit ※ Shaded areas in the fi gure indicate antibacterial material (excluding outlet nozzle areas).
Main unit
Lid
Drain tank
Recommended tools and hardware to be used for installation
Screwdriver
■ Prepare if required
Single wire for internal wiring
(Cable core: between 2.0mm² and 3.0mm²)
※ Not needed if the internal wiring is
complete.
is used.
How to open/close the front cover
(refer to Page 13)
Air fi lter
Open
Front cover
Pen
※ To mark position to insert metal
screw plugs in the wall.
Screw anchor
※ Use on concrete walls
− NA - 3 −
Accessories
Mounting screws
(5×30 Type 1 tapping screws)
Installation panel
Cord clip mounting screw
(4 × 14)
Cord clip
7 Wall reinforcement
※ Reinforces walls made of
materials other than concrete.
7
1
1
1