Digital Radio / Fm / Auxiliary Menus - Tivoli Audio ALBERGO + Mode D'emploi

11. Menu/seleCt: Press and hold to enter the main menu within each source mode
and press briefly to select items within the menu. For more, see the sections below
marked "Menu" for DAB, FM, and Auxiliary Menus.
12. Mono: Press to change the Stereo/Mono setting. The display will show "M" for
mono. This setting also affects the headphone output. For more, see the section
marked "Digital Radio/FM Reception".
13. baCK: Press to go back to the previous menu page.
note: With the Albergo+ in standby, you can control the display's backlight without having
to turn the Albergo+ on and accessing the menu. Press the remote's p button twice to
turn the backlight off. Press the remote's p button to turn the backlight on for 10 seconds.
Press the remote's p button two more times to restore the backlight.
Digital Radio (Dab/Dab+) Menu
In DAB mode, press and hold the Menu button on the remote to enter the main menu.
Use the pq buttons and the Select button to change the items within the menu. Use the
Back button to navigate back.
An asterisk (*) indicates the shown menu item is currently set.
note: Upon entering Digital radio mode, if the Station List is empty, an auto scan will initiate.
note: The Main Menu will time out if no action is taken after nine seconds.
1. auto sCan: Searches the entire frequency range. If you move the Albergo+ to
another location, you must perform a new scan so the radio will find stations in the
new location. To cancel the auto scan, press the Back button on the remote.
2. tiVoli eQ: Press the Select button and use pq and Select buttons to adjust the Bass
and Treble. The adjusted values will be shown in "User EQ". Press the Select button
to turn Loudness On or Off. Turning Loudness on when listening at low volume levels
is recommended since it boosts high and low frequencies resulting in a more natural
sound. Use the pq and Select buttons to activate any one of the pre-set EQ settings.
Selecting a preset EQ will over-ride any adjustment made to the Bass and Treble
settings, but Loudness will be unaffected. The "Flat" EQ restores the audio settings
to the factory defaults, meaning Bass and Treble will be re-set to zero. The "Flat" EQ
also restores Loudness Off. However, if the Bass and Treble had been adjusted, those
settings will still be shown in "User EQ". Simply selecting "User EQ" will reactivate the
Bass and Treble settings. In the EQ menu page, the numbers to the right hand side
indicate the bass and treble settings.
3. Manual tune: Press the pq buttons to manually tune specific DAB/DAB+
frequencies. The highlighted DAB station will tune automatically after 3 seconds, or
press the Enter button on the remote control.
4. DRC: Dynamic Range Control allows you change the sound level of stations to make
quiet passages louder to compensate for a noisy environment, or when listening at a low
volume level.
5. settings (a-f):
A. alaRM: See "How to Change Alarm Settings and Set the Alarm Via the Main Menu."
B. tiMe:
set time/Date: Press the Select button and use pq and Select buttons to ad-
just the hour and then minutes. You must also set the Auto update to "No update".
For more, refer to "Auto update" below.
12 – ENGLISH