Unpacking & Assembly - Echo PWE-1800 Manuel De L'opérateur

• After unpacking the ECHO POWER WASHER, lay out parts and accessories.
Familiarize yourself with the parts in the package by comparing them to those
listed on the "PACKAGE CONTENTS" page.
• The ECHO POWER WASHER requires some minor assembly. You'll need a
Phillips screwdriver install the high pressure hose hook and the nozzle tray.
NOTE: Some parts may or may not be already assembled.
• High pressure hose is stored on the hose reel. With the front of the power
washer facing towards you, insert the un-threaded end of the high pressure
hose into the square hole on the inner reel and begin turning the handle away
from you. When finished winding, push the handle in to lock it in place.
NOTE: The hose reel is only for storing the high pressure hose. The hose must be
completely removed from the hose reel each time you use the power washer.
• Slide the spray gun holder onto the left side of the washer when facing it. This
does not require any screws. (Fig. 1)
• Slip tab into slot and screw the nozzle tray on the bottom portion of the unit. (Fig.
2) When placing the gun with the lance attached the nozzle will rest in this tray.
• Easily remove the power cord from side of unit by swiveling the bottom cord
hook to the right or left until it faces up. The power cord then can be easily slid
off of the side of the power washer unit. (Fig. 3)
• Swivel cord hook back down when ready to wrap the cord back into place for
storage.
12
UNPACKING & ASSEMBLY
Fig. 1 Fig. 2
Fig. 3