MELICONI pratico 2 Mode D'emploi page 12

PROBLEM
The device does not respond and the indicator light
does not come on when a button is pressed.
The device does not respond but the indicator light
comes on.
When you press a button the indicator light fl ashes
and the device does not respond to commands.
The remote control does not execute all commands
correctly.
If you have any questions about the new Pratico 2 remote control:
•
read this Instructions Booklet carefully as it should allow you to solve most normal problems.
•
consult the www.meliconi.com website where you will fi nd all the answers you need quickly and easily.
2 year WARRANTY
The warranty is voided if the product is tampered
with or used improperly.
Remote control model: Pratico 2
Purchase date
The symbol showing a wheelie bin with a cross through it which appears on the device indicates that at the end of its useful life the
product must be collected separately from other waste. Therefore, at the end of the device's life, you must take it to appropriate centres
for the differentiated collection of electrical and electronic waste, or return it to the retailer when purchasing a new device of equivalent
type, on a one-for-one basis. Suitable differentiated collection to allow subsequent recycling of the decommissioned device, with
environmentally-compatible treatment and disposal, help to prevent any negative effects on the environment and health and to promote
the recycling of the materials of which the device is made. Improper disposal of the product by the user will be subject to the sanctions
in Legislative Decree No. 22/1997 (article 50 and subsequent articles of Legislative Decree No. 22/1997).
10
TROUBLESHOOTING
SOLUTION
Check that the batteries are charged and inserted
correctly and if necessary replace them with 2 new
1.5 V AA/LR06 alkaline batteries.
Make sure that the remote control is pointing at the
device and that there are no obstacles in the way.
If necessary, enter the remote control code again by
repeating the programming procedure.
Substitute the batteries, which are about to go fl at.
You may be using an incorrect code.
Enter the remote control settings again by repeating
the programming procedure.
INFO - LINE
Retailer stamp