Proper Use Of The Product; Important; Preparation For Use; Connection Of Accessories - POLTI Vaporetto EASY PLUS Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

PROPER USE OF THE PRODUCT

This appliance is intended for home use as a
steam generator as described and in accor-
dance with the instructions provided in this
manual. Please read these instructions care-
fully and keep them, as you may find them
useful in the future.
Polti declines liability for any damage or acci-
dent derived from any use of Vaporetto that
does not conform to the instructions contai-
ned in this booklet.

IMPORTANT

Before leaving our factory all our products are
rigorously tested. Your Vaporetto may con-
tain some residual water in the boiler tank
from the factory testing.

1. PREPARATION FOR USE

1.1 Unscrew the safety cap.
1.2 Fill the boiler tank with
up to 6.5 fl oz (200 ml) of
tap water, using the jug.
It is a good idea to check that the boiler tank is
empty before filling it.
WARNING: never exceed the maximum boi-
ler fill level of 6.5 fl oz (200 ml); always use
the jug supplied.
1.3
safety
checking
completely closed.
This operation must always
be carried out when the
boiler has cooled and with
the power cable disconnected from the
mains.
Carefully
screw
the
cap
back
on,
that
it
1.4 Connect the cable plug to a grounded
power supply of the correct voltage.
1.5 The "Steam Ready" lamp will turn on. Wait
for the steam ready indicator lamp to go out
(approx. 5 minutes). The appliance is ready
for use.
WARNING: if steam is escaping from the sa-
fety cap, switch the appliance off and unplug
it from the mains. Wait for two hour for the
appliance to cool before unscrewing the cap
and screwing it back on.

2. CONNECTION OF ACCESSORIES

2.1 FLEX
it clicks into place.
• In turn, the lance can be connected to the
flex and therefore all other accessories sup-
plied.
2.2 LANCE
The following accessories can be attached to the
lance:
is
| 8 |
To join the flex to the
appliance, bring the arrow
on the flex into line with the
single
notch
on
appliance and then rotate
the
flex
body
in
direction of the arrow, until
To release the flex, pull the
little lever above it and
rotate
in
the
opposite
direction from before.
To attach the lance, bring
the arrow on the lance into
line with the single notch
on the appliance and then
rotate the lance in the
direction of the arrow until
it clicks into place .
Window-washing accessory,
curved
nozzle,
brushes,
spatula
accessory
for
grouting.
Simply insert them into the
lance tip and rotate until
they lock into place.
the
the
round
and

Publicité

Table des Matières
loading

Table des Matières