FONESTAR MSH-883 Mode D'emploi page 9

CHANNEL SELECTION MODES IN THE RECEIVER
MANUAL MODE
To select an interference-free channel manually, follow the steps below:
AUTO-SCAN MODE
To select an interference-free channel automatically, follow the steps below:
Press the on/off button to switch the receiver on.
Press the SET button on the receiver.
Use the w/s buttons to select a channel and a certain frequency.
Press the on/off switch to switch the receiver on.
Press the SCAN button on the receiver and the receiver will
automatically scan for and select an interference-free channel.
Press the IR-SW button on the reciever and position the infrared
receivers from the receiver opposite those on the transmitter to
synchronize the frequency in both.
- 9 -
EN