FONESTAR MSH-883 Mode D'emploi page 5

BELT-PACK MICROPHONE (mod. MSHT-45P)
1.- Display:This shows information on the tuned frequency,such as the channel number, battery level, RF
signal level and audio signal. If the battery level is low, the display will light up red.
2.- w/s: for selecting desired options to set the wireless belt-pack microphone.
3.- SET: This button lets you select between the following setup options: channel number and frequency,
RF transmission level (high/low), battery type selection (1.2 V - rechargeable/1.5 V - alkaline) to show
the battery level correctly and the microphone transmitter lock. To do this, press the SET button con-
secutively and use the w/s buttons to select the options.
4.- IR: Wireless hand-held microphone infrared receiver.For tuning the receiver and the wireless hand-held
microphone, press the IR-SW button on the receiver and then place this IR receiver opposite the one
on the receiver.
5.- Battery compartment: Use two 1.5 V LR6-AA type batteries, alkalines or rechargeable.When you in-
sert the batteries, make sure that the polarity is correct.
6.- Aerial.
7.- VOL: Wireless belt-pack transmitter volume control.
8.- 3.5 mm mono jack connector for connecting a microphone or a desired audio source.
9.- ON/OFF:Transmitter on/off switch.
10.- GUITAR LINE/MIC.: input sensitivity selector.
11.- Contacts for recharging the rechargeable batteries in the wireless microphone in the recharge docking
station mod. MSC-2.
Note: when you press the SET button to setup the different microphone parameters, a MUTE indicator ap-
pears on the display and the microphone does not transmit audio when the parameters are being set.
- 5 -
EN