OSCAR OS10 Mode D'emploi page 2

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Installation...................................... ..................................... ...............................1&6-14
Operation................................... ..................................... .....................................15
Part of the reason for not working................................... ............................16
Repair &Maintenance............................. ..................................... ....................16
Felt cover collector installation......... ..................................... .....................26-29
Solar air collector panel is made of tempered glass with a pressure of 2400pa. Snow Loads: 80cm.
Installing your solar panel is so easy that you can do it yourself.
OS10/10H/20/22:1-2hours
;OS30/32/40/42: 2-3hours
Tools:
Optimal airflow: As far as possible inject the air into the driest room and extract from the most
humid room to eliminate the risk of leading the moisture through the rest of the building. The
thermostat and sensor should be protected from other heat sources or direct sunlight. They should be
located in a place with good ventilation, but not directly in the air flow from the solar collector.
The hole: Please distinguish wooden house and brick wall, so the correct electric drill is adopted. If it
is a brick wall, use a brick wall tool and a plastic expansion pipe. Take care not to drill into cables,
power sockets, pipes, etc. If the wall or roof is not flat, pay attention to waterproofing. You can use
polyurethane foam caulk, silicone or sealant to level it.
During installation, the outdoor air inlet must be facing downward and open. After installation,
remove the film on the aluminum alloy. It will be ugly after sun exposure.
The thermostat is a mechanical thermostat or an LCD thermostat, and the indoor air outlet is
automatic or manual. There are different configurations and installation methods, please refer to the
actual product.
Placement:
Installed facing south as much as possible. When placed 45 degrees from due south the system
also works, but with an approx. 15% lower performance. Note that by setting up two panels, e.g. one facing
east-southeast and one south-southwest, you can take full advantage of the available sunshine throughout the
day.
1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Os20Os30Os40Os22Os32Os42

Table des Matières