Installation Instructions; Permanent Installation - Gallagher MBS100 Mode D'emploi

3E4723 Gallagher MBS100 MBS200 MBS400 MBS800 Multi-Power User Manual
Power connection
9
10 Steel post mount

INSTALLATION INSTRUCTIONS

Step 1. Mount the Energizer
Mount the energizer on a post or wall, out of reach of children. Install in a
place where there is no risk of the energizer incurring mechanical damage,
and where there is no risk of the leads being chewed by animals. If possible,
install away from heavy electrical equipment e.g. pumps or other items that
may cause electrical interference.

Permanent Installation

a) Drill a single hole using a 4mm (5/32") diameter drill for timber walls, or
a suitable wall plug for brick and concrete walls (Figure 1).
b) Fix the 32mm screw provided into the wall leaving the head of the screw
3mm (1/8") out from the wall (Figure 2).
c) Place the energizer over and slide down onto the mounting screw
(Figure 3).
d) Secure energizer by fixing the 50mm screw into the wall through the
hole in the handle (Figure 4).
Figure 1
Connect 12V battery leadset or external mains
power adaptor.
Enables mounting on T-Post, Y Post or similar
Figure 2
Figure 3
Figure 4
9