Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Connection option B: SCART connector
Check whether your TV has a SCART socket. It does not matter whether it is
in use.
→ If it does not have one, proceed to connection option C.
SCART socket
1. Connect the amplifier to the TV SCART socket using the SCART cord supplied. If
the TV has more than one SCART socket, use the one that the TV manual recom-
mends for video (usually SCART 1 or AV1).
If the TV's SCART socket is being used by one or more external units (e.g. video,
DVD, digibox, satellite receiver), connect the amplifier between the TV and the ex-
ternal units. The units which are connected to the TV should be connected in series
(see illustration above). The DELAY knob on the backside of AutoMini should be
in OFF mode.
2. Set the switch on the front of the amplifier to the TV EXT position. One of the
lamps, TV or EXT, will come on, depending on whether the TV or an external unit
is being used at present.
→ Proceed to step 3: "Connecting the listening loop", page 13.
Please note! When correctly connected, the TV picture and sound will automatically be
changed to the programme source you selected (e.g. video, DVD, digibox, satellite receiver).
If you are watching video, DVD, satellite TV or another external unit and then switch to a
standard analogue TV channel, in some cases you may, however, receive the wrong sound on
the TV. In that case switch off the external unit, or all the external units, to obtain the cor-
rect sound. This phenomenon will never occur if you use connection options A or C.
TV
EXT
TV
EXT
MIC/LINE
MIC/LINE
ENGLISH
DVD
Video
Digibox
11
Publicité
Table des Matières
