Transistor 200 21 82 Manuel page 10

ENGLISH
2. Picking up the TV sound
The amplifier should be connected to the TV. The amplifier works just as well if
you already have one or more external units connected to the TV (e.g. video, DVD,
digibox, satellite receiver). There are three different ways of transmitting the sound.
For the best sound quality and simplest connection method, A is recommended as
the preferred option, and then option B and then C.
Connection option A: Line Out
Check whether your TV has a Line Out output (usually on the rear of the
L
TV, see TV user manual).
→
R
If your TV does not have a Line Out output, move on to connection option B.
Please note! Some TVs have a sound input on the front or on the side which looks
like a Line Out output but which is NOT able to transmit sound to an amplifier.
This is usually marked "Audio" and is located next to sockets marked "Video" and
"S-Video" (se TV user manual).
L
R
Line Out-utgång
1. Connect the Line Out cord between the TV and the amplifier's MIC/
LINE socket. The DELAY knob should be in OFF mode.
2. Set the switch on the front of the amplifier to the MIC/LINE position.
The relevant lamp will come on.
→ Proceed to step 3: "Connecting the listening loop", page 13.
10
MIC/LINE
TV EXT
MIC/LINE