Qlima DFA 1650 Premium Manuel D'utilisation page 53

• Fill the tank just below the maximum level in order to avoid spillage; the
gauge indicates the fuel level
• Replace the fuel tank cap
IGNITING AND OPERATING THE HEATER
STARTING THE HEATER
After refilling the fuel, put the plug into an earthed socket. Turn the ther-
mostat control knob to the desired setting (5 - 45 ºC.) and put the power
switch in the 'ON' position. The power indicator lamp will light up and the
heater will start.
The temperature display (DFA 2900 Premium and DFA 4100 Premium only)
will indicate:
• 'Lo' when the detected temperature is below 5 ºC
• The actual temperature when it is between 5 and 45 ºC
• 'Hi' when the detected temperature is above 45 ºC
When the heater doesn't start, the set temperature may be lower than the
detected temperature.
STOPPING THE HEATER
Put the power switch in 'OFF' position.
RESTART THE HEATER
Wait for minimum 20 seconds after stopping the heater in order to avoid
damage to the heater.
ADJUSTMENT OF AIR FLOW DIRECTION WITH THE LOUVER
The only way to adjust the air flow direction is by using the louver.
Approximately 28 degrees upward and 20 degrees downward.
Louver
Louver
Louver Handle Louver Handle
4
53