Eurotops 41072 Mode D'emploi page 32

T 4780 / MD4780
10. Press button to adjust to desired minute
11. Press button to confirm and settings are done
3) TO SET VOLUME
To set volume in measurement mode, press
To set volume in other modes, press [ ] button to enter sound mode directly.
Press to turn up or down the volume.
Press button to confirm and exit.
4) TO SET ALARM CLOCK
To set alarm in measurement mode, press
Press button to enter alarm mode. The alarm icon is flashing on the display.
Press button again to select between
When the desired alarm icon is flashing, press
To confirm your selection, press and hold
3. When alarm is ON, "Hour" will blink. Press
confirm.
4. "Minute" will blink. Press
settings are done. Press
5. To turn off the alarm, enter the alarm mode and select the desired alarm icon. Press
switch to the alarm OFF
5) APPLY ARM CUFF
TO
1. Pass the end of the cuff furthest from the tubing through the metal ring to form a loop. The smooth cloth should be the
inside of the cuff loop.
2. Put your left arm through the cuff loop. The bottom of the cuff should be approximately 2 – 3 cm above the elbow. The
white artery mark on the cuff should lie over the brachial artery on the inside of the arm. The tube should run down the
centre of arm and even with the middle finger. Do not place the arm cuff over heavy clothing (e.g. jacket or sweater sleeve)
as the blood pressure monitor will not be able to take proper measurement. Blood circulation in the arm should not be
restricted by tight clothing or other objects.
3. Pull the cuff so that the top and bottom edges are fitted evenly around your arm.
4. When the cuff is positioned correctly, press the sewn hook material firmly against the pile side of the cuff.
5. Make sure the cuff fits snugly around your arm. The cuff should make good contact with your skin.
button to turn off the unit. Press
button to turn off the unit.
and
button until the alarm icon stop flashing.
button to adjust to desired minute. Press
button to exit the alarm mode and turn the unit off.
icon. The alarm is turned off. Press
.
button to switch between ON
button to adjust the desired hour. Press
button to exit and turn the unit off.
button to enter sound mode.
and OFF .
button to
button to confirm and
button to