Kobalt 1303497 Mode D'emploi page 37

OPERATING INSTRUCTIONS
6. Turn saw on.
7. Position workpiece flat on table (V) with edge flush against rip fence (T). Let blade (W) build up to
full speed before feeding workpiece into blade.
8. Once blade (W) has made contact with workpiece, use hand closest to rip fence (T) for guidance.
Make sure edge of workpiece remains in solid contact with both rip fence (T) and surface of table
(V). If ripping a narrow piece, use push stick (D) and/or push blocks to move piece through cut and
past blade.
9. When cut is complete, turn saw off. Wait for blade (W) to come to a complete stop before removing
workpiece.
Making a Miter Cut
1. Remove rip fence (T).
2. Set blade (W) to correct depth for workpiece.
3. Set miter gauge (U) to 0° and tighten lock knob.
4. Make sure the wood is clear of the blade (W) before turning on the saw.
5. Turn the saw on.
6. Let the blade (W) build up to full speed before moving the workpiece into the blade (W).
7. Hand closest to blade (W) should be placed on miter gauge (U) lock knob and hand farthest from
blade (W) should be placed on workpiece. Feed workpiece into blade (W).
8. When cut is complete, turn saw off. Wait for blade (W) to come to a complete stop before removing
workpiece.
Making a Bevel Cross Cut
1. Remove rip fence (T).
2. Unlock bevel locking lever.
3. Adjust bevel angle to desired setting.
4. Lock bevel locking lever.
5. Set blade (W) to correct depth for workpiece.
6. Set miter gauge (U) to 0° and tighten lock knob.
7. Make sure wood is clear of blade (W) before turning on saw.
8. Turn saw on.
9. Let blade (W) build up to full speed before moving workpiece into blade (W).
10. Hand closest to blade (W) should be placed on miter gauge (U) lock knob and hand farthest from
blade (W) should be placed on workpiece. Feed workpiece into blade (W).
11. When cut is complete, turn saw off. Wait for blade (W) to come to a complete stop before
removing workpiece.
Making a Bevel Rip Cut
1. Remove miter gauge (U).
2. Unlock bevel locking lever.
3. Adjust bevel angle to desired setting.
4. Lock bevel locking lever.
5. Set blade (W) to correct depth for workpiece.
6. Position rip fence (T) at desired distance from blade (W) for cut and securely lock handle.
7. Make sure wood is clear of blade before turning on saw.
37
kobalttools.com